User Tools

Site Tools


Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
mission:resources:picoreflow [2016/09/21 09:25] – [picoReflow] chronomission:resources:picoreflow [2016/10/27 22:33] (current) – [Heating] chrono
Line 87: Line 87:
  
 ==== Heating ==== ==== Heating ====
 +
 +=== Load Wiring ===
 +
 +{{:mission:resources:picoreflow-ssr-load-connection.png|}}
 +
 +=== Signal Wiring ===
  
 SSR connected to P1-23 SSR connected to P1-23
  
 +^ PullDown Connection (default) ^ PullUp Connection (alternative) ^
 +| {{:mission:resources:picoreflow-ssr-signal-pulldown-connection.png?320|}} | {{:mission:resources:picoreflow-ssr-signal-pullup-connection.png?320|}} |
 +
 +
 +The default configuration has historically been to use the PullDown config, which results in an inverted control logic: When you pull GPIO23 low, the heater is switched on and when you pull GPIO23 high, the heater is switched off. 
 +
 +<WRAP round important>
 +**Please keep in mind that you'll have to have some script/code in your setup that makes sure that GPIO23 is pulled high as soon as the system has booted** (to be sure the heater is off) or change your setup to PullUp configuration instead, if you don't want to worry/bother.
 +</WRAP>
 ==== Cooling ==== ==== Cooling ====
  
Line 275: Line 290:
  
 A custom built oven to bake carbon composite parts.   A custom built oven to bake carbon composite parts.  
 +
 +==== WiFi/Raspberry Pi pottery kiln controller ====  
 +
 +{{:mission:resources:kilnrunning.jpg|}}
 +
 +http://succulentceramics.com/2016/10/07/wifiraspberry-kiln-controller/
 +
  
 {{tag>research lab reflow oven pid controller raspberry pi picofab software hardware}} {{tag>research lab reflow oven pid controller raspberry pi picofab software hardware}}