User Tools

Site Tools

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
mission:resources:picocnc [2015/01/30 21:02] – [DIY Direct-Drive Brushless Spindle] chronomission:resources:picocnc [2016/05/03 08:33] (current) – [DIY Direct-Drive Brushless Spindle] chrono
Line 115: Line 115:
 === Brushless Controller === === Brushless Controller ===
  
-Spindle control and speed is managed comfortably with a [[http://autoquad.org/wiki/wiki/esc32/|ESC32]] brushless engine speed controller originally intended to control our drone motors. Due to the open firmware nature of this module and the possibility to control the ESC through serial/CAN interface another module was purchased (additionally to the ones purchased for our Drone project) to be tested for the spindle setup.+Spindle control and speed is managed comfortably with a [[http://autoquad.org/wiki/wiki/esc32/|ESC32]] or [[mission:log:2016:04:30:vesc-open-source-bldc-esc]] brushless engine speed controller originally intended to control our drone motors. Due to the open firmware nature of this module and the possibility to control the ESC through serial/CAN interface another module was purchased (additionally to the ones purchased for our Drone project) to be tested for the spindle setup.
  
 Alternatively, you can hack/use a simple 555 circuit like the following and control another off-the-shelf RC ESC with that: Alternatively, you can hack/use a simple 555 circuit like the following and control another off-the-shelf RC ESC with that:
Trace:

Page Tools