Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| mission:log:2012:07:17:howto-disassemble-a-brushless-motor [2013/06/30 12:37] – [Step 4: Remove the bell] chrono | mission:log:2012:07:17:howto-disassemble-a-brushless-motor [2013/06/30 12:39] – [Step 4: Remove the bell] chrono | ||
|---|---|---|---|
| Line 52: | Line 52: | ||
| ===== Step 4: Remove the bell ===== | ===== Step 4: Remove the bell ===== | ||
| - | <note warning> | + | <WRAP round alert> |
| Never underestimate the force of these magnets. At this point and again, when you re-assemble the motor, the bell might easily snap back into its original position by itself if you let it slide too far up again. So please, take special care when executing the next step, because it will hurt, if a part of your skin is getting wedged in between the bell and the base, when they slam home. | Never underestimate the force of these magnets. At this point and again, when you re-assemble the motor, the bell might easily snap back into its original position by itself if you let it slide too far up again. So please, take special care when executing the next step, because it will hurt, if a part of your skin is getting wedged in between the bell and the base, when they slam home. | ||
| - | </note> | + | </WRAP> |
| {{: | {{: | ||
| Line 72: | Line 72: | ||
| {{: | {{: | ||
| - | <note tip> | + | <WRAP round tip> |
| * Use a hex bit to remove the screw | * Use a hex bit to remove the screw | ||
| - | </note> | + | </WRAP> |
| ===== Step 7: Go find a tool ===== | ===== Step 7: Go find a tool ===== | ||
| Line 80: | Line 80: | ||
| {{: | {{: | ||
| - | <note tip> | + | <WRAP round tip> |
| * In this case you need something that is smaller in diameter than the shaft but basically has the same requirements as step 2: Less dense than steel, can transfer energy without braking/ | * In this case you need something that is smaller in diameter than the shaft but basically has the same requirements as step 2: Less dense than steel, can transfer energy without braking/ | ||
| * Place the food end of the chopstick at the center of the shaft and gently tap on the top with the hammer until the shaft is driven out. | * Place the food end of the chopstick at the center of the shaft and gently tap on the top with the hammer until the shaft is driven out. | ||
| - | </note> | + | </WRAP> |
| ===== Finally ===== | ===== Finally ===== | ||